ZoneFlow

Soil: the settings

How the soil takes water in (soil type, drainage, slope), how it holds it (mulch), and what a soil moisture probe may decide.

Soil Type

Decides how much water one pulse may give before it runs off: about 3 mm on clay, 7 on clay loam, 15 on loam, 20 on sandy loam, 30 on sand. "Not sure" uses a cautious 10 mm.

Not sure? Squeeze a handful of moist soil. Falls apart: sandy. Holds a ball that crumbles when poked: loam. Holds its shape and rolls into a ribbon between your fingers: clay.

Drainage

Slow-draining soil (a hard, compact layer underneath, water that stands after rain) takes about a third less per pulse, and the soak between pulses should be an hour.

Slope

Water runs off a slope before it soaks in. A moderate slope adds one pulse to every watering, a steep one two.

Mulch

  • Mulched (the start): mulch, a full canopy or turf covers the soil, so little water evaporates. No change to the watering.
  • Not mulched: bare soil loses more water to sun and wind. The adjustment below is applied.

Mulch ET Adjustment

Only with Not mulched: how much more (or less) the routine watering gives. 20 % to start with, −50 % to +70 %.

  • Young plants with bare soil between them (vegetables, herbs, flowers): +25 to +35 %
  • Shrub or young tree, partly shaded ground: +15 to +25 %
  • Mature tree with a full canopy: +10 to +15 %
  • Windy or fully sunny spot: a few % more
  • Heavy clay, deep shade, soil that stays wet: −20 % (down to −50 %)

Large negative values cut watering a lot. Use them only if the soil really stays wet, and check it for a week or two.

Soil Moisture Dry and Wet Threshold

Only with a soil moisture probe. At or below Dry, the soil is dry: the zone waters at its next watering time even if the days between waterings are not up (a share of the dose for the days that have passed, at least a quarter). At or above Wet, the soil is wet: a due watering is skipped. In between, the schedule decides. 20 % and 60 % to start with.

The percentage of a cheap probe is not a true measure of water: it changes with the soil, salt and temperature, and 30 % in sand is not 30 % in clay. Find your own two numbers:

  • Wet: water the spot well (or wait for a good rain) and read the probe the next day, once the extra water has drained. Set Wet a few points below that reading.
  • Dry: watch the reading as the soil dries. When the plant first needs water (the soil at root depth feels dry, or leaves start to droop in the morning), note the reading. Set Dry a few points above it.

Put the probe where the roots are, in full contact with the soil, out of a sprinkler's direct spray. A probe that has not reported for 24 hours is ignored. If wet readings hold the watering back for twice the days between waterings, you get a message to check the probe. More in ET, temperature tiers or a soil sensor.

When Soil Gets Wet During Watering

Only with a soil moisture probe.

  • Finish the watering (the start): every planned pulse is given.
  • Stop at the wet level: before each later pulse the probe is read, and at the Wet level or more the rest is not given. The soak between pulses gives the water time to reach the probe. A watering stopped this way counts as the watering.

It applies to the routine watering only, never the deep soak. A press of Run Routine Now is never cut short.