Status, notifications and repairs
Status: plain language, per zone
Each zone has a Status sensor that says what it's doing and why, in Home Assistant's own language — "Routine watering done at 05:30: 12 mm in 40 min · next Mon 05:30", "Skipped: the soil is wet (72%)", "Skipped: 8 mm of rain forecast". Its code attribute is the same thing as a stable key, for automations that would rather not match on the sentence itself. The next_routine and next_deep_soak attributes hold the time of each next watering (empty while the zone is paused). While the soil is drying out after heavy rain, the Status keeps saying so, with when watering resumes, beside later decisions such as "counted as done by rain". The Status also says how much the next watering is expected to give, for example "Next watering Mon 05:30, estimated 12 mm", and names both the next routine watering and the next deep soak. The routine after a deep soak is dated a full interval after it, because a finished deep soak counts as the routine watering too. It is left out when there is nothing to estimate. The Next Irrigation Estimate sensor is hidden by default, because Days Until Next Run says the same. It still works, and you can unhide it under the entity's settings. If a zone didn't water and you want to know why, see Why didn't it water today?
Greenhouse and indoor zones also have a Greenhouse Status sensor that does the same for the climate: what the vents, fans, heater and misters are doing, and why. You get a phone message when a sensor failsafe starts and when it ends.
Notifications, your way
Pick, per zone: all phone notifications, warnings only (faults and anything that needs a look), or none — except an alert that a valve may still be open, which always comes through regardless of this setting. Notifications and the Status sentence follow Home Assistant's language; the CSV log stays in English.
Buttons on phone messages
Messages to the Home Assistant companion app about a watering cancelled for rain, an overdue zone or a fertilizing reminder carry buttons: Water 10 min, Snooze today and Fertilized. This needs the app's notify service.
Weekly summary
Optional, per zone: pick a weekday, and at the time you chose when you set up the zone (18:00 to start with; change it under Configure) you get one phone message covering that zone — water given, rain, how often a run was held back, and the next watering. The fertilizing reminder comes at its own time, 09:00 to start with, also chosen at setup.
Repairs
An unavailable valve, a sensor offline for days, a missing notify target, or a flow rate that was never calibrated show up under Settings → System → Repairs, and clear themselves once fixed. A phone that no longer exists, a sensor offline for days and a flow rate that was never set have a Fix button, so you can sort them out on the spot. The zone card also has Check my setup, a plain checklist with the problems first. A warning that is wrong for your zone, for example "the flow rate is still the example value" when that really is your flow rate, has an Ignore button (administrators, with a confirmation). It moves to an Ignored list at the bottom with Show again, and no longer counts toward the result. If it goes away and later comes back, it is a new warning. Greenhouse and indoor zones add a few of their own: a device that did not respond after two tries, a mister that would not switch off (misting stops until you press Reset Irrigation Lock), and an inside sensor that has been down for 10 minutes.
A tidy device page
Settings sit under Configuration, technical sensors under Diagnostic, and anything a zone can't use yet (forecast sliders without a weather entity, deep-soak sliders with deep soak off, and so on) is hidden — still working, still keeping its value, back by itself once you set that feature up. A Download diagnostics button on the device page gives everything needed for a bug report.