- Use Your Weather Station's Rain Sensor for Irrigation
2026-10-31
Skip the extra rain gauge. Pick the right rain sensor from Ecowitt, Ambient, Tempest or Davis and set its type in ZoneFlow 1.6.5.
- Set a Timer on the Valve Itself: The Safety Net for When Home Assistant Stops
2026-10-20
ZoneFlow closes your valve when a watering ends. If Home Assistant, the network or the power fails while it is open, nothing is left to close it. Three small things on the hardware cover that.
- Try ZoneFlow in Your Browser: A Live Irrigation Demo
2026-10-11
Explore a working ZoneFlow garden in your browser, no Home Assistant needed. Make it rain, heat things up, skip a day and add a zone to see what it does.
- Why Didn't It Water Today? Reading Your ZoneFlow Status
2026-10-05
A skipped watering is usually the system doing its job. Here is how to find out why ZoneFlow held back, and which skips are normal.
- Several Irrigation Valves on One Pump: How to Set Them Up
2026-10-05
Two valves open on one pump or mains supply split its flow. Test it with a bucket and set a Shared pump ID so zones take turns.
- How to Measure Your Irrigation Flow Rate With a Bucket
2026-10-05
Measure your drip or sprinkler flow rate with a jug, a watch and a tape measure in ten minutes, then let ZoneFlow do the maths.
- ET, Temperature Tiers or a Soil Sensor for Watering
2026-10-04
Temperature tiers, ET or a soil sensor: what each does well, where it fails, and which to use for lawns, vegetables, trees and pots.
- Greenhouse Climate Control With Home Assistant and ZoneFlow
2026-10-03
Run fans, vents, misters and a heater from ZoneFlow, with failsafes for when a sensor dies and support for several crops in one greenhouse.
- DIY Rain Gauge for ZoneFlow: From Misol Bucket
2026-09-29
Build a cheap rain gauge for ZoneFlow from a $10 Misol tipping bucket and an ESP32 or an Aqara sensor. The ESP32 can sit 15 m away, indoors.