ZoneFlow

Rain, forecast and frost: the settings

These settings decide how much the rain counts, when heavy rain holds the watering back, when a forecast skips it, and when cold stops it. Most need a rain sensor; without one, see Rain without a gauge.

How rain is counted

Every day's rain is counted on its own, and how much of it reaches the roots depends on how much fell that day:

  • Up to the Rain Ignored Below amount in a day (3 mm to start with) counts as nothing: it wets the leaves, the mulch and the top of the soil and dries off again.
  • Light rain (above that, up to 5 mm) counts by the Light efficiency, from nothing at the ignored amount to the full Light share at 5 mm.
  • Moderate rain (5 to 10 mm) by the Moderate efficiency.
  • Heavy rain (10 to 20 mm and more) by the Heavy efficiency.

Between these steps the share changes smoothly. The useful rain since the last watering is taken off the next watering. If it is more than a whole watering, the zone counts as watered by the rain, and the rest carries over to the next one. See How it decides.

Rain Ignored Below (per day)

A day's rain up to this amount counts as nothing toward the watering: a little drizzle only wets the surface. 3 mm to start with, 0 to 5 mm in steps of 0.5. Lower it for shallow roots or sandy soil, so light rain counts too. The three Rain Efficiency settings still decide how much of the larger rain counts. It is copied with Copy settings and presets.

Rain Efficiency - Light (3-5mm)

The share of a light shower that reaches the roots. 0.2 (20 %) to start with. Agricultural water balance guides count almost none of a light shower in dry, hot weather, because it evaporates before it soaks in, and a lawn, a mulch layer or a tree canopy catches the first few millimetres.

  • Mulched beds, lawn, under a dense canopy: 0 to 0.1
  • Bare soil, small plants: 0.2 to 0.3
  • Cool, cloudy, humid season, when showers soak in before they dry: up to 0.5

Rain Efficiency - Moderate (5-10mm)

The share of a moderate rain that reaches the roots. 0.6 to start with. Most of it soaks in; some is caught by leaves and mulch or evaporates. Usual range 0.5 to 0.75.

Rain Efficiency - Heavy (10-20mm+)

The share of a heavy rain that is still useful to the plant. 1.0 (all of it) to start with. Two things waste heavy rain: water that runs off, and water that drains below the roots once the root zone is full. That is why it depends on the plant's roots and the soil:

  • Deep roots (trees, established shrubs, lawn on deep soil): 0.9-1.0
  • Medium roots (most vegetables and flowers) in loam: 0.8-0.9
  • Shallow roots (salad, herbs, strawberries, seedlings, raised beds and pots): 0.6-0.8
  • Shallow roots on sandy soil: 0.5-0.7
  • Clay soil or a slope, where heavy rain runs off: 0.6-0.7

Why roots matter: loam holds roughly 1.5 to 2 mm of usable water per centimetre of depth, sand about half of that. A 25 cm root zone in sand is full after about 20 mm; a heavy rain beyond that drains past roots that are only 25 cm deep, while a tree with roots a metre deep keeps all of it.

Routine Dry-Down Holdoff

After heavy rain (see the three thresholds below) the routine watering waits this many days, so waterlogged soil can drain and the roots get air. 4 days to start with, 1 to 10.

  • Thirsty, shallow-rooted plants or sandy soil: 1 to 2 days
  • Most gardens: 3 to 4 days
  • Drought-tolerant plants, clay soil, plants that hate wet feet (avocado, citrus, olive, succulents): 5 to 7 days

A press of Run Routine Now ignores it. Self-tuning (below) can move it by itself.

Self-Tuning

On (the start): ZoneFlow learns from how you use the buttons. If you keep pressing Run Routine Now before a watering is due, the dry-down holdoff gets shorter. If you keep pressing Snooze Today, it gets longer. The two cancel each other out, and it never goes outside 1 to 10 days. Off: the buttons never change a setting.

Self-Tuning Presses Needed

How many presses in a row it takes before the holdoff moves. 3 to start with, 2 to 10. Raise it if you often press the buttons for other reasons (a party, a visitor).

Self-Tuning Step

How much one nudge moves the holdoff. 0.5 days to start with, 0.5 to 2.

Dry-Down Rain Threshold (24h, 4 days, 7 days)

How much rain counts as heavy enough to start the dry-down holdoffs (routine and deep soak). Crossing any one of the three is enough. To start with: 35 mm in 24 hours, 50 mm in 4 days, 100 mm in 7 days.

  • Sandy soil that drains in a day, or a climate with frequent downpours: raise them.
  • Clay, or plants that rot in wet soil: lower them.

Moving a threshold does not turn old rain into a new storm.

Dry-Down Restarts After More Rain

From ZoneFlow 1.7.9. While a zone is drying out after heavy rain, more rain can start the dry-down over, so watering waits for the soil to dry again. This setting is how much more. To start with it is 10 mm (0.4 inches), and 0 turns it off.

Since 1.7.10 it counts only rain that falls within 24 hours after the dry-down started or restarted. A restart gives a new 24 hours, so a storm that keeps going keeps the dry-down on. Ordinary rain several days later does nothing to it, apart from the usual heavy-rain thresholds above.

  • It restarts quietly, with no alert. The Status and Why? show the new end.
  • It follows the routine dry-down only. Rain after the routine dry-down has ended does not bring it back.
  • If you edit Last Significant Rain by hand, the edit is honored: rain before the edit is not counted.
  • It is on by default for existing zones. Set it to 0 to keep the old behavior.
  • It is copied with Copy settings and presets.

Raise it if short showers should not delay watering. Lower it for soil that stays wet a long time, such as clay.

Rain Gauge mm per Tip (Calibration)

Only for a tipping-bucket gauge: how much rain one tip means. Check it with the gauge's specification or by pouring a measured amount of water in. See Calibration.

Pre-Irrigation Cancel Threshold (30min)

If more than this fell in the last 30 minutes, a watering does not start, and a watering already running stops before its next pulse. 3 mm to start with. It needs a rain sensor that reports every few minutes. Raise it if light drizzle cancels waterings you wanted; lower it to stop at the first real shower.

Forecast Rain Skip Threshold

Needs a weather entity. If today's forecast says at least this much rain, the watering waits. 3 mm to start with. Lower it for plants that like it wet or to save water; raise it if forecasts in your area often promise rain that does not come.

Forecast Rain Probability Threshold

A forecast with any rain counts too when its chance of rain is at least this. 60 % to start with. Raise it if your forecast says "60 %" most days.

Forecast Dry-Spell Override

How many days the forecast may keep promising rain that never comes before ZoneFlow waters anyway. 2 days to start with. This is the forecast setting worth choosing per plant:

  • Seedlings, pots, vegetables in hot weather: 1 to 2 days
  • Established, drought-tolerant plants (trees, natives, succulents): 4 to 7 days

A forecast only ever delays a watering; it never cancels one for good. An unreadable forecast never stops a watering.

Frost Guard Temperature

A watering that comes due while it is colder than this waits, checks again every hour (up to six times) and otherwise waits for its next day. 2 °C to start with. On clear, calm nights the ground can freeze while a thermometer at head height still shows 2 to 4 °C, so keep it at 1 to 3 °C where mornings freeze. In a frost-free climate leave it. Slide it to the lowest (−10 °C) to switch it off. See Frost guard and Pause.