ZoneFlow

Deep soak: the settings

A deep soak is a big, slow watering every couple of weeks that wets the soil deep down, so roots grow deep. It is for plants with deep roots in real ground: trees, established shrubs, perennials and lawn. For salad, herbs, strawberries, pots and raised beds turn it off: the routine watering does everything.

A finished deep soak also counts as the routine watering. If a deep soak comes due the day after a routine watering, it waits for the next routine day and takes its place. Heavy rain can count as a deep soak by itself.

Enable the Deep Soak Cycle

On or off for this zone. The routine watering runs either way.

Deep Soak Target Depth

How much water a deep soak gives, in mm. 25 mm to start with, 15 to 40. Roughly, 1 mm of water wets 0.5 to 1 cm of loam that has dried to the point where you would water, less in clay and more in sand. 25 mm wets roughly 20-40 cm.

  • Shrubs and young trees: 20 to 25 mm
  • Fruit trees and established trees: 25 to 35 mm
  • Lawn: 15 to 20 mm

Deep Soak Interval

The fewest days between deep soaks. 14 days to start with, 3 to 30. Plants with medium-deep roots or a hot, dry climate: 7 to 10. Deep-rooted trees that like long dry spells: 18 to 30.

Deep Soak Subsoil Dry-Down Holdoff

After heavy rain, the deep soak waits this many days (8 to start with, 4 to 14). The deep soil stays wet much longer than the top, so this is usually longer than the routine holdoff.

Deep Soak Rain Ceiling (14d)

If at least this much rain fell in the last 14 days, the deep soak is skipped: the rain already soaked the ground. 40 mm to start with. 0 means any rain at all skips it.

Deep Soak Pulse Count, Soak Interval and Minimum Pulse Length

The same as for the routine watering (see How much water: the settings), for the deep soak. A deep soak is several times bigger, so on clay it usually needs more pulses and the full hour of soak. The minimum pulse is 5 minutes to start with.

Deep Soak Max Safety Runtime Cap

The longest a deep soak may run, in minutes, all pulses together. 124 minutes to start with. A deep soak that would need longer is not run at all and you get a message, because it usually means the flow rate is wrong. Very slow drippers can need several hours for a real deep soak: then raise the cap to just above target depth ÷ flow rate (25 mm at 0.1 mm a minute is 250 minutes). Do not raise it to the maximum "to be safe".